I had an angular clock working great for some months until some yanked the usb cable too hard and broke off the connection on the board. You sent me a replacement board. After a couple of years I’ve finally gotten around to replacing it (hey so many toys so little time) and it works while powered up connected to a pc usb. When it loses power on shutdown and starts up it always goes to 6-0-0 instead of correct time. New battery installed. Ideas?
Hi Tony. do you have a coin cell battery installed (plus side up) in the designated battery slot? That’s pretty much the only reason I would expect the time to reset when power is removed. Maybe the battery is dead, or otherwise not making good contact to the printed circuit board?